Filter
Top Products
NE-4100 Series User’s Manual Network Enabler Administrator
7-14
2. There are three options for adding a module:
y If the module already shows up, you may select it with a check mark and then click OK.
y If the module does not show up, you may do a broadcast search for the module by
clicking Rescan.
y You may manually specify the IP address of the module by selecting Input manually and
entering the address.
3. Once the target has been selected, it will show up on the list in the Monitor module list. Note
that monitoring does not actually begin until Go is selected from the context menu.
Load Configured COM Port
Load Configured COM Port searches your PC for any COM ports that have already been
mapped to a network module and adds that module to the Monitor module list. Select Load
Configured COM Port in the Monitor context menu.