Filter
Top Products
NE-4100 Series User’s Manual Web Console Configuration
6-9
Port Alias
Setting Factory Default Necessity
1 to 15 characters
(E.g., PLC-No.1)
None Optional
This function is designed for future use. You may enter a string to help in the module’s serial port
from other serial ports.
Serial Parameters
ATTENTION
Refer to the serial communication parameters in your serial device’s user’s manual. The module’s
serial parameters should be the same as the parameters used by your serial device.
Baud Rate
Setting Factory Default Necessity
50 bps to 115.2 Kbps for PCB V1.x
110 bps to 230.4 Kbps for PCB V2.x
115.2 Kbps Required
The module can be set for baud rates between 50 bps and 115.2 Kbps for PCB V1.x and between
110 bps to 230.4 Kbps for PCB V2.x.
Data Bits
Setting Factory Default Necessity
5, 6, 7, 8 8 Required
When the user sets Data Bits to 5 bits, the Stop Bits setting will automatically change to 1.5 bits.
Stop Bits
Setting Factory Default Necessity
1, 2 1 Required
Stop Bits will be set to 1.5 when Data Bits is set to 5 bits.
Parity
Setting Factory Default Necessity
None, Even, Odd, Space, Mark None Required
Flow control
Setting Factory Default Necessity
None, RTS/CTS, DTR/DSR, XON/XOFF RTS/CTS Required
FIFO
Setting Factory Default Necessity
Enable, Disable Enable Required
Each module’s serial port provides a 16-byte FIFO both in the Tx and Rx directions. Disable the
FIFO setting when your serial device does not have a FIFO to prevent data loss during
communication.