Filter
Top Products
Chapter 3: Web Management Interface
Multi-Tech Systems, Inc. FF240-IP Admin User Guide 43
T.38
Fax ID
Enter the Fax ID you want the FaxFinder to send out.
Fax Method
Use the drop-down box to select T.38 Re-invite, T.38 Pass Through or T.38 Direct as your fax method.
Fax Codec
Check the box for each fax codec you want in use. G 7.11 Alaw and G 7.11 µlaw are available depending
on your Fax Method (T.38 Re-invite and T.38 Pass Through only).
Redundancy Level
Enter a redundancy level for the FaxFinder. Default is 3.
Max Buffer
Enter the maximum buffer to be used for the FaxFinder. Default is 4000.
Extension Source
Select the extension source to be used by the FaxFinder.
Options are: SIP to Header or SIP Diversion Header.
Extension Digits
Select the manner in which extension digits are used.
Options are: Use All; Use First Only; Use Last Only.
Channel Reservation
If you want channels reserved for specific use only, enter the number of channels reserved for Inbound
Only or Outbound Only in these fields.
Max Rate
Select the maximum fax transmission rate for the channels from the drop-down list.
Options are: 2400; 4800; 9600; 12000; 14400; 16800; 19200; 21600; 24000; 28800; 31200; 33600.
Error Correction
Choose if you want to have fax Error Correction on or off.
Dial Prefix
Enter a dial prefix to be applied to all channels if necessary. The dial prefix is appended as a prefix to all
faxes being sent.
Jitter Buffer Delay
Enter the jitter buffer delay (in milliseconds). Default is 30 ms.
Max Datagram
Enter the maximum datagram size allowed. Default is 948.
Extension Length
Enter the extension length allowed for the channels.
Save button
When you
have entered your information, be sure to click the save button before navigating
away from this page, else your changes will be lost.