Filter
Top Products
Multi-Tech Systems, Inc. RouteFinder RF802EW User Guide
Chapter 5 - Telnet
50
Note: If your ISP uses dynamic IP addressing, leave the External Port IP address and
External Gateway IP address at the default values of 0.0.0.0. Set the External IP Netmask to
the default value of 255.255.255.0.
LAN-to-LAN Access
To use the WAN port to connect to another LAN, you must configure the following:
Enter the IP and Netmask address of the network to which you are connecting.
g). Async Port Settings
The async port may be used for IP Routing or Remote Access. For more information,
see the Async Port section of the RouteFinder Manager chapter.
IP Routing
If you will use the async port for IP Routing, enter the following information as
described:
Telephone Number
Enter the phone number the async device must dial to connect to the remote system.
User Name
Enter the User Name that will be used for authentication on the remote system.
Password
Enter the Password associated with the User Name for the remote system.
Idle Timeout
Enter the amount of idle time allowed to pass before the connection times out. The default
value is 5 minutes.
Serial Baudrate
Use the list to select the appropriate baudrate of the modem attached to your async port.
You may need to select a lower speed to ensure a quality connection.
Modem Pre-Initial String
Consult your modem or ISDN TA User Guide for this information. The default value will work
for most analog modems.
Modem Initial String
Consult your modem or ISDN TA User Guide for this information.
Modem Dialup String
Consult your modem or ISDN TA User Guide for this information.
Modem Hangup String
Consult your modem or ISDN TA User Guide for this information.