Filter
Top Products
63
Chapter 6 - RouteFinder Manager
Multi-Tech Systems, Inc. RouteFinder RF802EW User Guide
Allow Remote Dial-In - This option allows a remote site to dial-in to this network.
1. From the IP Routing Settings dialog box, select Allow Remote Dial-In.
2. Click Remote Authentication Settings.
3. The Remote Connection Authentication dialog box displays.
4. Select one of three methods to define the authentication protocol to be used when a
remote site is dialing in to your site:
None - No authentication needed.
PAP - User Name and unencrypted Password are transmitted over the network.
CHAP - DHCP sends a key which is used to encrypt the user name and password.
Encryption provides added protection from potential interception of authentication
information.
Note: If you select PAP or CHAP, you must indicate where the authentication
process should occur, by selecting Use Local Settings, Use Local Client List, or
Use RADIUS Authentication. Refer to Remote Connection Authentication Settings
following this section.
5. Click OK when complete.
Callback Settings - From a remote site, you can trigger your RF802EW to establish a
connection with your ISP.
1. Click Callback Settings and select one of three call back options:
No Callback
Trigger (ISP) Server Connection - The RouteFinder will establish a connection
with the ISP server after a remote user dials into the asynchronous port. The
device can be triggered to automatically establish a connection with the ISP in
one of two ways:
1. The ISP server is dialed after the RF802EW receives a PPP (modem)
connection from a remote user.
2. The RF802EW makes the connection to the ISP server after receiving a
regular telephone call. The remote user calls the RF802EW async port to
trigger the connection to the ISP server.
Remote Callback - After dialing, the RF802EW hangs up and waits for the
remote site to callback. You must enter the callback telephone number (the
telephone number the device should call) in the Tel Number box.
2. Click OK to complete.