Filter
Top Products
User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Switching Commands 8-45
202-10009-01_060204
set garp timer join
This command sets the GVRP join time per port and per GARP. Join time is the interval between
the transmission of GARP Protocol Data Units (PDUs) registering (or re-registering) membership
for a VLAN or multicast group.
This command has an effect only when GVRP is enabled. The time is from 10 to 100
(centiseconds)
Default 20 centiseconds (0.2 seconds)
Format
set garp timer join <10-100>
Mode Interface Config
no set garp timer join
This command sets the GVRP join time per port and per GARP to 20 centiseconds (0.2 seconds).
This command has an effect only when GVRP is enabled.
Format
no set garp timer join
Mode Interface Config
set garp timer join all
This command sets the GVRP join time for all ports and per GARP. Join time is the interval
between the transmission of GARP Protocol Data Units (PDUs) registering (or re-registering)
membership for a VLAN or multicast group.
This command has an effect only when GVRP is enabled. The time is from 10 to 100
(centiseconds)
Default 20 centiseconds (0.2 seconds)
Format
set garp timer join all <10-100>
Mode Global Config
no set garp timer join all
This command sets the GVRP join time for all ports and per GARP to 20 centiseconds (0.2
seconds). This command has an effect only when GVRP is enabled.
Format
no set garp timer join all
Mode Global Config