Filter
Top Products
User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Switching Commands 8-89
202-10009-01_060204
If 0 (defined as the default CIST ID) is passed as the <mstid>, then this command sets the Bridge
Priority parameter to a new value for the common and internal spanning tree. The bridge priority
value again is a number within a range of 0 to 61440. The twelve least significant bits will be
masked according to the 802.1s specification. This will cause the priority to be rounded down to
the next lower valid priority.
Default 32768
Format spanning-tree mst priority <mstid> <0-61440>
Mode Global Config
no spanning-tree mst priority
This command sets the bridge priority for a specific multiple spanning tree instance to the default
value, i.e. 32768. The instance <mstid> is a number that corresponds to the desired existing
multiple spanning tree instance.
If 0 (defined as the default CIST ID) is passed as the <mstid>, then this command sets the Bridge
Priority parameter for the common and internal spanning tree to the default value, i.e. 32768.
Format spanning-tree mst priority <mstid>
Mode Global Config
spanning-tree mst vlan
This command adds an association between a multiple spanning tree instance and a VLAN. The
VLAN will no longer be associated with the common and internal spanning tree. The instance
<mstid> is a number that corresponds to the desired existing multiple spanning tree instance. The
<vlanid> corresponds to an existing VLAN ID.
Format spanning-tree mst vlan <mstid> <vlanid>
Mode Global Config
no spanning-tree mst vlan
This command removes an association between a multiple spanning tree instance and a VLAN.
The VLAN will again be associated with the common and internal spanning tree. The instance
<mstid> is a number that corresponds to the desired existing multiple spanning tree instance. The
<vlanid> corresponds to an existing VLAN ID.
Format no spanning-tree mst vlan <mstid> <vlanid>