Filter
Top Products
User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Switching Commands 8-67
202-10009-01_060204
Mode Interface Config
snmp trap link-status all
This command enables link status traps for all interfaces.
Note: This command is valid only when the Link Up/Down Flag is enabled (see “snmp-server
enable traps linkmode”).
Format
snmp trap link-status all
Mode Global Config
no snmp trap link-status all
This command disables link status traps for all interfaces.
Note: This command is valid only when the Link Up/Down Flag is enabled (see “snmp-server
enable traps linkmode”).
Format
no snmp trap link-status all
Mode Global Config
spanning-tree
This command sets the STP mode for a specific port-channel (LAG). This is the value specified
for STP Mode on the Port Configuration Menu. 802.1D mode is the default. The interface is a
logical slot and port for a configured port-channel. The
all option sets all configured port-
channels (LAGs) with the same option.
Format
spanning-tree {<logical slot/port> | all} {off |
802.1d | fast}
Mode Global Config
The mode is one of the following:
802.1d IEEE 802.1D-compliant STP mode is used
fast Fast STP mode is used
off STP is turned off