Filter
Top Products
User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
9-20 Routing Commands
202-10009-01_060204
hostroutesaccept
This command enables the RIP hostroutesaccept mode.
Default Enabled
Format
hostroutesaccept
Mode Router RIP Config
no hostroutesaccept
This command disables the RIP hostroutesaccept mode.
Format
no hostroutesaccept
Mode Router RIP Config
ip address
This command configures an IP address on an interface.
The value for <ipaddr> is the IP Address of the interface.
The value for <subnetmask> is a 4-digit dotted-decimal number which represents the Subnet Mask
of the interface. This changes the label "IP address" in "show ip interface."
Format
ip address <ipaddr> <subnetmask>
Mode Interface Config
no ip address
This command deletes an IP address from an interface.
The value for <ipaddr> is the IP Address of the interface.
The value for <subnetmask> is a 4-digit dotted-decimal number which represents the Subnet Mask
of the interface.
Format
no ip address <ipaddr> <subnetmask>
Mode Interface Config