Filter
Top Products
User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
9-18 Routing Commands
202-10009-01_060204
no distribute-list out
This command is used to specify the access list to filter routes received from the source protocol.
Format
no distribute-list <1-199> out {rip | bgp | static |
connected}
Mode Router OSPF Config
distribute-list out
This command is used to specify the access list to filter routes received from the source protocol.
Default 0
Format
distribute-list <1-199> out {ospf | bgp | static |
connected}
Mode Router RIP Config
no distribute-list out
This command is used to specify the access list to filter routes received from the source protocol.
Format
no distribute-list <1-199> out {ospf | bgp | static |
connected}
Mode Router RIP Config
no default-information originate
This command is used to control the advertisement of default routes.
Format
no default-information originate
Mode Router RIP Config
encapsulation
This command configures the link layer encapsulation type for the packet. Acceptable values for
<encapstype> are Ethernet and SNAP. The default is Ethernet.
Format
encapsulation {ethernet | snap}
Mode Interface Config