Filter
Top Products
User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
8-92 Switching Commands
202-10009-01_060204
Access Mode Shows whether the operator is able to change parameters on the
switch (Read/Write) or is only able to view them (Read Only). As
a factory default, admin has Read/Write access and guest has
Read Only access. There can only be one Read/Write user and up
to five Read Only users.
SNMPv3 AccessMode This field displays the SNMPv3 Access Mode. If the value is set
to
ReadWrite, the SNMPv3 user will be able to set and retrieve
parameters on the system. If the value is set to
ReadOnly, the
SNMPv3 user will only be able to retrieve parameter information.
The SNMPv3 access mode may be different than the CLI and
Web access mode.
SNMPv3 Authentication This field displays the authentication protocol to be used for the
specified login user.
SNMPv3 Encryption This field displays the encryption protocol to be used for the
specified login user.
users name
This command adds a new user (account) if space permits. The account <username> can be up to
eight characters in length. The name may be comprised of alphanumeric characters as well as the
dash (‘-’) and underscore (‘_’). The <username> is not case-sensitive.
Six user names can be defined.
Format
users name <username>
Mode
Global Config
no users name
This command removes an operator.
Format
no users name <username>
Mode Global Config
Note: The admin user account cannot be deleted.