Filter
Top Products
User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
9-26 Routing Commands
202-10009-01_060204
ip ospf cost
This command configures the cost on an OSPF interface. The <cost> parameter has a range of 1 to
65535.
Default 10
Format
ip ospf cost <1-5535>
Mode Interface Config
no ip ospf cost
This command configures the default cost on an OSPF interface. The <cost> parameter has a range
of 1 to 65535.
Default 10
Format
no ip ospf cost
Mode Interface Config
ip ospf dead-interval
This command sets the OSPF dead interval for the specified interface.
The value for <seconds> is a valid positive integer, which represents the length of time in seconds
that a router's Hello packets have not been seen before its neighbor routers declare that the router is
down. The value for the length of time must be the same for all routers attached to a common
network. This value should be some multiple of the Hello Interval (i.e. 4).
Valid values range for <seconds> is from 1 to 2147483647.
Default 40
Format
ip ospf dead-interval <1-2147483647>
Mode Interface Config
no ip ospf dead-interval
This command sets the default OSPF dead interval for the specified interface.
Format
no ip ospf dead-interval
Mode Interface Config