Filter
Top Products
User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
CLI Commands: Differentiated Services 10-3
202-10009-01_060204
diffserv
This command sets the DiffServ operational mode to active. While disabled, the DiffServ
configuration is retained and can be changed, but it is not activated. When enabled, Diffserv
services are activated.
Format
diffserv
Mode Global Config
no diffserv
This command sets the DiffServ operational mode to inactive. While disabled, the DiffServ
configuration is retained and can be changed, but it is not activated. When enabled, Diffserv
services are activated.
Format
no diffserv
Mode Global Config
Class Commands
The 'class' command set is used in DiffServ to define:
Traffic Classification Specify Behavior Aggregate (BA), based on DSCP, and Multi-
Field (MF) classes of traffic (name, match criteria)
Service Levels Specify the BA forwarding classes / service levels. Conceptually,
DiffServ is a two-level hierarchy of classes: 1. Service/PHB, 2.
Traffic Class
This set of commands consists of class creation/deletion and matching, with the class match
commands specifying layer 3, layer 2, and general match criteria. The class match criteria are also
known as class rules, with a class definition consisting of one or more rules to identify the traffic
belonging to the class. Note that once a class match criterion is created for a class, it cannot be
changed or deleted - the entire class must be deleted and re-created.
The CLI command root is
class-map.