Filter
Top Products
User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Command Line Interface Structure 5-3
202-10009-01_060204
logical slot/port This parameter denotes a logical slot number and logical port
number assigned. This is applicable in the case of a port-channel
(LAG). The operator can use the logical slot number and the logi-
cal port number to configure the port-channel.
Conventions
Network addresses are used to define a link to a remote host, workstation or network. Network
addresses are shown using the following syntax:
Double quotation marks such as "System Name with Spaces" set off user defined strings. If the
operator wishes to use spaces as part of a name parameter then it must be enclosed in double
quotation marks.
Empty strings (““) are not valid user defined strings.
Command completion finishes spelling the command when enough letters of a command are typed
to uniquely identify the command word. The command may be executed by typing <enter>
(command abbreviation) or the command word may be completed by typing the <tab> or <space
bar> (command completion).
The value 'Err' designates that the requested value was not internally accessible. This should never
happen and indicates that there is a case in the software that is not handled correctly.
The value of '-----' designates that the value is unknown.
Table 5-1. Network Address Syntax
Address Type Format Range
ipaddr
A.B.C.D 0.0.0.0 to 255.255.255.255
(decimal)
macaddr
YY:YY:YY:YY:YY:YY hexidecimal digit pairs