NETGEAR 7300S Network Router User Manual


 
User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
Switching Commands 8-59
202-10088-01, March 2005
port. With either option, VLAN tagged frames are forwarded in
accordance to the 802.1Q VLAN specification.
Ingress Filtering May be enabled or disabled. When enabled, the frame is dis-
carded if this port is not a member of the VLAN with which this
frame is associated. In a tagged frame, the VLAN is identified by
the VLAN ID in the tag. In an untagged frame, the VLAN is the
Port VLAN ID specified for the port that received this frame.
When disabled, all frames are forwarded in accordance with the
802.1Q VLAN bridge specification. The factory default is dis-
abled.
GVRP
May be enabled or disabled.
Default Priority The 802.1p priority assigned to tagged packets arriving on the port.
System Utility Commands
This section describes system utilities. The commands are divided into two functional groups:
Show commands display switch settings, statistics, and other information.
Configuration commands configure features and options of the switch. For every
configuration command, there is a show command that displays the configuration setting.
traceroute
This command is used to discover the routes that packets actually take when traveling to their
destination through the network on a hop-by-hop basis. <ipaddr> should be a valid IP address.
[port] should be a valid decimal integer in the range of 0(zero) to 65535. The default value is
33434.
The optional port parameter is the UDP port used as the destination of packets sent as part of the
traceroute. This port should be an unused port on the destination system.
Format
traceroute <ipaddr> [port]
Mode Privileged EXEC