Filter
Top Products
User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
Quick Start up 6-5
202-10088-01, March 2005
Quick Start up Uploading from Switch to Out-of-Band PC (Only
XMODEM)
Table 6-5. Quick Start-up IP Address Using Switch as Layer-3 Device
Command Details
# vlan data base Enter VLAN configuration mode
(vlan) # vlan routing 1 Enable VLAN routing interface, “0/2/1” created
(vlan) # exit Exit from VLAN configuration mode
# config Enter global configuration mode
(config) # ip routing Enable global IP routing mode
(config) # interface 0/2/1 Enter interface configuration mode
(config) # ip address <ip addr> <netmask> Enter desired IP address and netmask
(config) # exit Exit from global configuration mode
Table 6-6. Quick Start up Uploading from Switch to Out-of-Band PC (XMODEM)
Command Details
copy {
nvram:startup-config |
nvram:errorlog |
nvram:msglog |
nvram:traplog} <url>
The types are:
config - configuration file
errorlog - error log
system trace - system trace
traplog - trap log
The URL must be specified as:
xmodem:filepath/fileName
This starts the upload and also displays the mode of
uploading and the type of upload it is and confirms the
upload is taking place.
For example:
If the user is using HyperTerminal, the user must
specify where the file is going to be received by the
PC.