NETGEAR 7300S Network Router User Manual


 
User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
Routing Commands 10-29
202-10088-01, March 2005
Auto Summary Mode Select enable or disable from the pulldown menu. If you select
enable groups of adjacent routes will be summarized into single
entries, in order to reduce the total number of entries The default
is enable.
Host Routes Accept Mode Select enable or disable from the pulldown menu. If you select
enable the router will be accept host routes. The default is enable.
Global Route Changes The number of route changes made to the IP Route Database by
RIP. This does not include the refresh of a route's age.
Global queries - The number of responses sent to RIP queries from other sys-
tems.Default Metric
Sets a default for the metric of redistributed routes.This field dis-
plays the default metric if one has already been set or blank if not
configured earlier. The valid values are (1 to 15)
Default Metric Sets a default for the metric of redistributed routes.This field dis-
plays the default metric if one has already been set or blank if not
configured earlier. The valid values are (1 to 15)
Default Route Advertise The default route.
show ip rip interface brief
This command displays general information for each RIP interface. For this command to display
successful results routing must be enabled per interface (i.e. ip rip).
Format
show ip rip interface brief
Mode Privileged EXEC and User EXEC
Slot/Port Valid slot and port number separated by forward slashes.
IP Address The IP source address used by the specified RIP interface.
Send Version The RIP version(s) used when sending updates on the specified
interface. The types are none, RIP-1, RIP-1c, RIP-2.
Receive Version The RIP version(s) allowed when receiving updates from the
specified interface. The types are none, RIP-1, RIP-2, Both
RIP Mode RIP administrative mode of router RIP operation; enable acti-
vates, disable de-activates it.
Link State The mode of the interface (up or down).