NETGEAR 7300S Network Router User Manual


 
User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
8-82 Switching Commands
202-10088-01, March 2005
client-identifier
This command specifies the unique identifier for a DHCP client. Unique-identifier is a valid
notation in hexadecimal format. In some systems, such as Microsoft DHCP clients, the client
identifier is required instead of hardware addresses. The unique-identifier is a concatenation of the
media type and the MAC address. For example, the Microsoft client identifier for Ethernet address
c819.2488.f177 is 01c8.1924.88f1.77 where 01 represents the Ethernet media type. Refer to the
"Address Resolution Protocol Parameters" section of RFC 1700, Assigned Numbers for a list of
media type codes.
Default
None
Format client-identifier <uniqueidentifier>
Mode DHCP Pool Config
no client-identifier
This command deletes the client identifier.
Format no client-identifier
Mode DHCP Pool Config
client-name
This command specifies the name for a DHCP client. Name is a string consisting of standard
ASCII characters.
Default
None
Format client-name <name>
Mode DHCP Pool Config
no client-name
This command removes the client name.
Format no client-name
Mode DHCP Pool Config