Filter
Top Products
User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
6-4 Quick Start up
202-10088-01, March 2005
Note: The user should do a copy system:running-config nvram:startup-config after
configuring the network parameters so that the configurations are not lost.
Note: The IP address assigned to network in the above table will not be routable. If access to
management CPU via the routable interface is desired, use the
ip command.
Table 6-4. Quick Start-up IP Address Using Switch as Layer-2 Device
Command Details
show network
(in User EXEC)
Displays the Network Configurations
IP Address - IP Address of the interface
Default IP is 0.0.0.0
Subnet Mask - IP Subnet Mask for the interface
Default is 0.0.0.0
Default Gateway - The default Gateway for this interface
Default value is 0.0.0.0
Burned in MAC Address - The Burned in MAC Address used for in-
band connectivity
Locally Administered MAC Address - Can be configured to allow a
locally administered MAC address
MAC Address Type - Specifies which MAC address should be used for
in-band connectivity
Network Configurations Protocol Current - Indicates which network
protocol is being used
Default is none
Management VLAN Id - Specifies VLAN id
Web Mode - Indicates whether HTTP/Web is enabled.
Java Mode - Indicates whether java mode is enabled.
network parms
(in Privileged EXEC)
network parms <ipaddr> <netmask> [<gateway>]
IP Address range from 0.0.0.0 to 255.255.255.255
Subnet Mask range from 0.0.0.0 to 255.255.255.255
Gateway Address range from 0.0.0.0 to 255.255.255.255