NETGEAR 7300S Network Router User Manual


 
User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
8-118 Switching Commands
202-10088-01, March 2005
Spanning Tree (STP) Commands
This chapter provides a detailed explanation of the Spanning Tree commands. The commands are
divided into two functional groups:
Show commands display switch settings, statistics, and other information.
Configuration commands configure features and options of the switch. For every
configuration command, there is a show command that displays the configuration setting.
Note: The software platform STP default mode is IEEE 802.1s, but the legacy IEEE 802.1D mode
is available. To change to the legacy IEEE 802.1D mode, set the STP operational mode to
disabled, then enable the IEEE 802.1D mode from the source code. Recompile the software to
operationally enable the IEEE 802.1D mode. With the IEEE 802.1D mode operationally enabled,
the rapid configuration and multiple instances features are not available. If the rapid configuration
and multiple instances capabilities are required, use the IEEE 802.1s mode which is compatible
with the legacy IEEE 802.1D standard.
spanning-tree max-hops
This command sets the MSTP Max Hops parameter to a new value for the common and internal
spanning tree. The max-hops value is in a range of 1 to 127.
Default 20
Format spanning-tree max-hops <1-127>
Mode Global Config
no spanning-tree max-hops
This command sets the Bridge Max Hops parameter for the common and internal spanning tree to
the default value.
Format no spanning-tree max-hops
Mode Global Config
spanning-tree
This command sets the spanning-tree operational mode to enabled.