Filter
Top Products
User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
Switching Commands 8-21
202-10088-01, March 2005
network protocol
This command specifies the network configuration protocol to be used. If you modify this value
change is effective immediately. The parameter
bootp indicates that the switch periodically sends
requests to a Bootstrap Protocol (BootP) server or a dhcp server until a response is received.
none
indicates that the switch should be manually configured with IP information.
Default none
Format
network protocol {none | bootp | dhcp}
Mode Privileged EXEC
telnetcon maxsessions
This command specifies the maximum number of telnet connection sessions that can be
established. A value of 0 indicates that no telnet connection can be established. The range is 0 to 5.
Default 5
Format
telnetcon maxsessions <0-5>
Mode
Privileged EXEC
no telnetcon maxsessions
This command sets the maximum number of telnet connection sessions that can be established to
the default value.
Format
no telnetcon maxsessions
Mode Privileged EXEC
telnetcon timeout
This command sets the telnet connection session timeout value, in minutes. A session is active as
long as the session has been idle for the value set. A value of 0 indicates that a session remains
active indefinitely. The time is a decimal value from 0 to 160.
Note: Changing the timeout value for active sessions does not become effective until the session is
reaccessed. Any keystroke will also activate the new timeout duration.
Default 5
Format
telnetcon timeout <0-160>
Mode Privileged EXEC