Filter
Top Products
User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
Quality of Service (QoS) Commands 11-41
202-10088-01, March 2005
Modes Global Config
Interface Config
classofservice ip-precedence-mapping
This command maps an IP precedence value to an internal traffic class. The ipprecedence and
trafficclass can both range from 0-7, although the actual number of available traffic classes
depends on the platform. The 'no' form of this command is not supported.
Format classofservice ip-precedence-mapping <ipprecedence>
<trafficclass>
Modes Global Config
Interface Config
classofservice trust
This command sets the class of service trust mode of an interface. The mode can be set to trust one
of the Dot1p (802.1p), IP Precedence, or IP DSCP packet markings.
Format classofservice trust <dot1p/ip-precedence/ip-dscp>
Mode Global Config
Interface Config
no classofservice trust
This command sets the interface mode to untrusted.
Format no classofservice trust
Modes Global Config
Interface Config
cos-queue max-bandwidth
This command specifies the maximum transmission bandwidth limit for each interface queue.
Also known as rate shaping, this has the effect of smoothing temporary traffic bursts over time so
that the transmitted traffic rate is bounded. The total number of queues supported per interface is
platform specific.
Format cos-queue max-bandwidth <bw-0> <bw-1> … <bw-n>
Modes Global Config
Interface Config