NETGEAR 7300S Network Router User Manual


 
User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
Mode-based CLI 7-1
202-10088-01, March 2005
Chapter 7
Mode-based CLI
The CLI groups all the commands in appropriate modes according to the nature of the command.
A sample of the CLI command modes are described below. Each of the command modes support
specific 7300S Series L3 Switch commands.
User Exec Mode
Privileged Exec Mode
Global Config Mode
•Vlan Mode
Interface Config Mode
Line Config Mode
Policy Map Mode
Policy Class Mode
Class Map Mode
Router Config RIP Mode
DHCP Pool Configuration Mode
The Command Mode table captures the command modes, the prompts visible in that mode and the
exit method from that mode.
Table 7-1. Command Mode
Command Mode Access Method Prompt
Exit or Access Next
Mode
User Exec Mode This is the first level of
access. Perform basic
tasks and list system
information.
Switch> Enter Logout command
Privileged Exec Mode From the User Exec
Mode, enter the
enable
command.
Switch# To exit this mode, enter
exit or press Ctrl-Z.