Filter
Top Products
User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
11-2 Quality of Service (QoS) Commands
202-10088-01, March 2005
Note: The CLI mode is changed to Mac-Access-List Config when this command is successfully
executed.
Format mac access-list extended <name>
Mode Global Config
no mac access-list extended <name>
This command deletes a MAC ACL identified by <name> from the system.
Format no mac access-list extended <name>
Mode Global Config
mac access-list extended rename <name> <newname>
This command changes the name of a MAC Access Control List (ACL). The <name> parameter
is the name of an existing MAC ACL. The <newname> parameter is a case-sensitive
alphanumeric string from 1 to 31 characters uniquely identifying the MAC access list.
This command fails if a MAC ACL by the name <newname> already exists.
Format mac access-list extended rename <name> <newname>
Mode Global Config
{deny|permit} <srcmac> <srcmacmask> <dstmac>
<dstmacmask>
This command creates a new rule for the current MAC access list. Each rule is appended to the list
of configured rules for the list. Note that an implicit 'deny all' MAC rule always terminates the
access list.
Note: The 'no' form of this command is not supported, as the rules within an ACL cannot be
deleted individually. Rather, the entire ACL must be deleted and re-specified.
A rule may either deny or permit traffic according to the specified classification fields. At a
minimum, the source and destination MAC value and mask pairs must be specified, each of which
may be substituted using the keyword any to indicate a match on any value in that field. The bpdu
keyword may be specified for the destination MAC value/mask pair indicating a well-known
BPDU MAC value of 01-80-c2-xx-xx-xx (hex), where 'xx' indicates a don't care. The remaining
command parameters are all optional.