NETGEAR 7300S Network Router User Manual


 
User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
8-106 Switching Commands
202-10088-01, March 2005
no set igmp
This command disables IGMP Snooping on the system.
Format
no set igmp
Mode Global Config
set igmp
This command enables IGMP Snooping on a selected interface. If an interface which has IGMP
Snooping enabled is enabled for routing or is enlisted as a member of a port-channel (LAG),
IGMP Snooping functionality will be disabled on that interface. IGMP Snooping functionality will
subsequently be re-enabled if routing is disabled or port-channel (LAG) membership is removed
from an interface that has IGMP Snooping enabled.
Default disabled
Format
set igmp
Mode Interface Config
no set igmp
This command disables IGMP Snooping on a selected interface.
Format
no set igmp
Mode Interface Config
set igmp groupmembership-interval
This command sets the IGMP Group Membership Interval time on the system. The Group
Membership Interval time is the amount of time in seconds that a switch waits for a report from a
particular group on a particular interface before deleting the interface from the entry. This value
must be greater than the IGMP Maximum Response time value. The range is 2 to 3600 seconds.
Default 260
Format
set igmp groupmembership-interval <2-3600>
Mode Global Config
no set igmp groupmembership-interval
This command sets the IGMP Group Membership Interval time on the system to 260 seconds.