Filter
Top Products
User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
Switching Commands 8-27
202-10088-01, March 2005
ServPort Configuration Protocol Current Indicates what network protocol was used on
the last, or current power-up cycle, if any.
Burned in MAC Address The burned in MAC address used for in-band connectivity.
SNMP Community Commands
show snmpcommunity
This command displays SNMP community information. Six communities are supported. You can
add, change, or delete communities. The switch does not have to be reset for changes to take
effect.
The SNMP agent of the switch complies with SNMP Version 1 (for more about the SNMP
specification, see the SNMP RFCs). The SNMP agent sends traps through TCP/IP to an external
SNMP manager based on the SNMP configuration (the trap receiver and other SNMP community
parameters).
Format
show snmpcommunity
Mode Privileged EXEC
SNMP Community Name The community string to which this entry grants access. A valid
entry is a case-sensitive alphanumeric string of up to 16 charac-
ters. Each row of this table must contain a unique community
name.
Client IP Address - An IP address (or portion thereof) from which this device will
accept SNMP packets with the associated community. The
requesting entity's IP address is ANDed with the Subnet Mask
before being compared to the IP Address. Note: that if the Subnet
Mask is set to 0.0.0.0, an IP Address of 0.0.0.0 matches all IP
addresses. The default value is 0.0.0.0
Client IP Mask - A mask to be ANDed with the requesting entity's IP address
before comparison with IP Address. If the result matches with IP
Address then the address is an authenticated IP address. For
example, if the IP Address = 9.47.128.0 and the corresponding
Subnet Mask = 255.255.255.0 a range of incoming IP addresses
would match, i.e. the incoming IP Address could equal
9.47.128.0 - 9.47.128.255. The default value is 0.0.0.0