Filter
Top Products
User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
Routing Commands 10-15
202-10088-01, March 2005
encapsulation
This command configures the link layer encapsulation type for the packet. Acceptable values for
<encapstype> are Ethernet and SNAP. The default is Ethernet.
Format
encapsulation {ethernet | snap}
Mode Interface Config
Restrictions Routed frames are always Ethernet encapsulated when a frame is
routed to a VLAN.
Bootp/DHCP Relay Commands
This chapter provides a detailed explanation of the BootP/DHCP Relay commands. The
commands are divided by functionality into the following different groups:
• Show commands are used to display switch settings, statistics and other information.
• Configuration Commands are used to configure features and options of the switch. For every
configuration command there is a show command that will display the configuration setting.
• Copy commands are used to transfer configuration and informational files to and from the
switch.
bootpdhcprelay cidoptmode
This command enables the circuit ID option mode for BootP/DHCP Relay on the system.
Default
disabled
Format bootpdhcprelay cidoptmode
Mode Global Config
no bootpdhcprelay cidoptmode
This command disables the circuit ID option mode for BootP/DHCP Relay on the system.
Format
no bootpdhcprelay cidoptmode
Mode Global Config