Filter
Top Products
104 IP Routing Configuration and Management
The ip rip out-policy command is executed in the Interface
Configuration mode.
Virtual Router Redundancy Protocol (VRRP) commands
The Virtual Router Redundancy Protocol (VRRP) is designed to eliminate
the single point of failure that can occur when the single static default
gateway router for an end station is lost.
This section describes the CLI commands used to configure VRRP.
router vrrp enable command
The router vrrp enable command is used to globally enable VRRP
on a switch.
The syntax of the router vrrp enable command is:
router vrrp enable
The router vrrp enable command is executed in the Global
Configuration mode.
no router vrrp enable command
The no router vrrp enable command is used to globally disable
VRRP on a switch.
The syntax of the no router vrrp enable command is:
no router vrrp enable
The no router vrrp enable command is executed in the Global
Configuration mode.
router vrrp command
The router vrrp command is used to place the switch into Router
Configuration mode for the purposes of VRRP configuration.
The syntax of the router vrrp command is:
router vrrp
The router vrrp command is executed in the Global Configuration mode.
ping-virtual-address enable command
The ping-virtual-address enable command is used to enable ICMP
echo replies from VRRP associated addresses.
The syntax of the ping-virtual-address enable command is:
Nortel Ethernet Routing Switch 5500 Series
Configuration-IP Routing Protocols
NN47200-503 03.01 Standard
5.1 27 August 2007
Copyright © 2005-2007, Nortel Networks
.