Filter
Top Products
IP routing configuration using the CLI 87
no area parameters
Parameter Description
ip_address Specifies the Area ID expressed as IP address (A.B.C.D).
import-summaries
{enable}
Controls the import of summary link state advertisements
into stub areas. This setting has no effect on other areas.
range {subnet_mask}
{nssa-entlink |
summary-link}
Used to specify range parameters for the OSPF area.
The no area command is executed in the Router Configuration mode.
Note: The configuration of a totally stubby area (no summary
advertising) is a two step process. First, define an area with the
import flag set to
noexternal. Second, disable import summaries
in the same area with the command no area <ip_address>
import-summaries enable.
as-boundary-router command
The as-boundary-router command is used to denote a router as an
Autonomous System Boundary Router.
The syntax of the as-boundary-router command is:
as-boundary-router {enable}
The as-boundary-router command is executed in the Router
Configuration mode.
no as-boundary-router command
The no as-boundary-router command is used to withdraw a router as
an Autonomous System Boundary Router.
The syntax of the no as-boundary-router command is:
no as-boundary-router {enable}
The no as-boundary-router command is executed in the Router
Configuration mode.
default-cost ethernet command
The default-cost ethernet command is used to define the default
cost metric of an ethernet (10 Mbps) port.
The syntax of the default-cost ethernet command is:
default-cost ethernet <metric_value>
Nortel Ethernet Routing Switch 5500 Series
Configuration-IP Routing Protocols
NN47200-503 03.01 Standard
5.1 27 August 2007
Copyright © 2005-2007, Nortel Networks
.