Filter
Top Products
98 IP Routing Configuration and Management
ip ospf network {broadcast | passive}
The ip ospf network command is executed in the Interface
Configuration mode.
ip ospf primary-md5-key command
The ip ospf primary-md5-key command is used to configure the
primary MD5 key to use for authentication in instances where interface
authentication uses an MD5 key.
The syntax of the ip ospf primary-md5-key command is:
ip ospf primary-md5-key <key_value>
The <key_value> parameter is an integer value between 1 and 255.
The ip ospf primary-md5-key command is executed in the Interface
Configuration mode.
ip ospf priority command
The ip ospf priority command is used to assign a priority to the
interface for the purposes of Designated Router election.
The syntax of the ip ospf priority command is:
ip ospf priority <priority_value>
The <priority_value> parameter is the priority value assigned to the
interface. This is an integer value between 0 and 255.
The ip ospf priority command is executed in the Interface
Configuration mode.
ip ospf retransmit-interval command
The ip ospf retransmit-interval command is used to define the
number of seconds between link state advertisement retransmissions for
adjacencies belonging to this interface.
The syntax of the ip ospf retransmit-interval command is:
ip ospf retransmit-interval <interval>
The <interval> parameter is the number of seconds between
retransmissions. This is an integer value between 0 and 3600.
The ip ospf retransmit-interval command is executed in the
Interface Configuration mode.
Nortel Ethernet Routing Switch 5500 Series
Configuration-IP Routing Protocols
NN47200-503 03.01 Standard
5.1 27 August 2007
Copyright © 2005-2007, Nortel Networks
.