Filter
Top Products
72 IP Routing Configuration and Management
ip rip holddown command
The ip rip holddown command is used to set the value of the holddown
timer on the RIP interface.
The syntax of the ip rip holddown command is:
ip rip holddown <timer_value>
The <timer_value> parameter is an integer value between 0 and 360
seconds.
The ip rip holddown command is executed in the Interface
Configuration mode.
ip rip in-policy command
The ip rip in-policy command is used to add an in policy to this RIP
interface.
The syntax of the ip rip in-policy command is:
ip rip in-policy <policy_name>
The <policy_name> parameter represents the name of a previously
configured switch policy.
The ip rip in-policy command is executed in the Interface
Configuration mode.
no ip rip in-policy command
The no ip rip in-policy command is used to remove a in policy for
the RIP interface.
The syntax of the no ip rip in-policy command is:
no ip rip in-policy <policy_name>
The <policy_name> parameter represents the name of a previously
configured switch policy.
The no ip rip in-policy command is executed in the Interface
Configuration mode.
ip rip listen command
The ip rip listen command is used to allow this interface to listen for
RIP advertisements.
The syntax of the ip rip listen command is:
Nortel Ethernet Routing Switch 5500 Series
Configuration-IP Routing Protocols
NN47200-503 03.01 Standard
5.1 27 August 2007
Copyright © 2005-2007, Nortel Networks
.