Filter
Top Products
224 IP Routing Configuration and Management
—End—
RIP interface configuration
RIP interface configuration is used to tailor RIP to the individual interfaces.
To configure a RIP interface, perform the following procedure:
Step Action
1
Select IP Routing > RIP from the Device Manager menu. The RIP
dialog is opened. Select the Interface tab. This tab is illustrated
below.
RIP dialog - Interface tab
2
Using the fields provided, configure the interface. The following table
describes these fields.
Interface tab fields
Field Description
Address The IP address of the RIP interface. This field is for
organizational purposes only and cannot be edited.
Send Sets the RIP version sent on this interface. The
following values are valid:
•
doNotSend - No RIP updates sent on this
interface.
•
ripVersion1 - RIP updates compliant with RFC
1058.
•
rip1Compatible - Broadcasts RIPv2 updates
using RFC 1058 route subsumption rules.
•
ripVersion2 - Multicasting RIPv2 updates.
The default is rip1Compatible.
Receive Sets the RIP version received on this interface: rip1,
rip2, or rip1OrRip2 The default is rip1OrRip2. Note
that rip2 and r ip1OrRip2 imply reception of multicast
packets.
Nortel Ethernet Routing Switch 5500 Series
Configuration-IP Routing Protocols
NN47200-503 03.01 Standard
5.1 27 August 2007
Copyright © 2005-2007, Nortel Networks
.