Filter
Top Products
IP routing configuration using the Java Device Manager 215
Insert Static Route fields
Field Description
Dest The destination IP address of the route.
0.0.0.0 is considered the default route. Multiple
routes to a single destination can appear in
the table, but access to such multiple entries
is dependent on the table-access mechanisms
defined by the network management protocol
in use.
Mask The destination mask of the route.
NextHop The IP address of the next hop of this route.
In the case of a route bound to an interface
that is realized through a broadcast media,
the value of this field is the agent IP address
on that interface.
Metric This field represents the cost of the static route.
It is used to choose the best route (the one
with the smallest cost) to a certain destination.
This field has a range of 1 to 65535. If this
metric is not used, the value is set to -1.
Enable Enable the new static route.
4
Click Insert. The new static route is displayed on the Static Routes
tab.
—End—
ARP tab
The ARP tab is used to configure Address Resolution Protocol (ARP)
entries for the switch. To configure the ARP tab, follow this procedure:
Step Action
1
Open the IP screen by selecting IP Routing > IP from the menu.
Select the ARP tab. This tab is illustrated below.
ARP tab
Nortel Ethernet Routing Switch 5500 Series
Configuration-IP Routing Protocols
NN47200-503 03.01 Standard
5.1 27 August 2007
Copyright © 2005-2007, Nortel Networks
.