Filter
Top Products
IP routing configuration using the CLI 69
The timers basic holddown command is executed in the Router
Configuration mode.
timers basic timeout command
The timers basic timeout command is used to set the RIP timeout
timer.
The syntax of the timers basic timeout command is:
timers basic timeout <timer_value>
The <timer_value> parameter represents a value between 15 and
259200 seconds.
The timers basic timeout command is executed in the Router
Configuration mode.
timers basic update command
The timers basic update command is used to set the RIP update timer.
The syntax of the timers basic update command is:
timers basic update <timer_value>
The <timer_value> parameter represents a value between 0 and 360
seconds.
The default timers basic update command is executed in the
Router Configuration mode.
ip rip advertise-when-down command
The ip rip advertise-when-down command is used to enable RIP
advertisements on the interface being configured even when that interface
is not operational. The subnet on which the switch has a RIP enabled
interface is advertised even if that particular network is no longer connected
(no link in the connected VLAN is in the Link-Up state). This setting will
take effect whenever the value is changed by the user or after the first
Link-Down transition.
The syntax of the ip rip advertise-when-down command is:
ip rip advertise-when-down {enable}
Advertise when down functionality is disabled by default.
The ip rip advertise-when-down command is executed in the
Interface Configuration mode.
Nortel Ethernet Routing Switch 5500 Series
Configuration-IP Routing Protocols
NN47200-503 03.01 Standard
5.1 27 August 2007
Copyright © 2005-2007, Nortel Networks
.