Filter
Top Products
IP routing configuration using the CLI 75
The <rip_version> parameter indicates the RIP version. The valid
values for this parameter are:
•
rip1
•
rip1orrip2
•
rip2
The ip rip receive command is executed in the Interface Configuration
mode.
ip rip send command
The ip rip send command is used to set the RIP version sent on this
interface.
The syntax of the ip rip send command is:
ip rip send version <rip_version>
The <rip_version> parameter indicates the RIP version. The valid
values for this parameter are:
•
notsend
•
rip1
•
rip1comp
•
rip2
The ip rip send command is executed in the Interface Configuration
mode.
ip rip supply command
The ip rip supply command is used to enable RIP route advertisement
on this interface.
The syntax of the ip rip supply command is:
ip rip supply {enable}
The ip rip supply command is executed in the Interface Configuration
mode.
no ip rip supply command
The no ip rip supply command is used to disable RIP route
advertisement on this interface.
The syntax of the no ip rip supply command is:
no ip rip supply {enable}
Nortel Ethernet Routing Switch 5500 Series
Configuration-IP Routing Protocols
NN47200-503 03.01 Standard
5.1 27 August 2007
Copyright © 2005-2007, Nortel Networks
.