Filter
Top Products
148 IP Routing Configuration and Management
ASBR distribution example
Use the following procedure to replicate the ASBR distribution example:
Step Action
1
Configure RIP.
Configure the RIP interface on R1 by configuring port 1/31 as a
brouter port in VLAN 100 and enabling RIP on this interface.
5530-24TFD(config)# interface fast 1/31
5530-24TFD(config-if)# brouter port 1/31 vlan 100
subnet 10.1.1.41/30
5530-24TFD(config)# router rip
5530-24TFD(config-router)# network 10.1.1.41
2
Configure the RIP interface for RIP version 2 mode only.
5530-24TFD(config)# router rip enable
5530-24TFD(config)# interface vlan 100
5530-24TFD(config-if)# ip rip receive version rip2 send
version rip2
3
Configure the OSPF interface.
Configure port 2/7 as a brouter port in VLAN 200 and enable OSPF
on this interface.
5530-24TFD(config)# interface fast 2/7
5530-24TFD(config-if)# brouter port 2/7 vlan 200 subnet
10.1.1.2/30
5530-24TFD(config-if)# router ospf
5530-24TFD(config-router)# network 10.1.1.2
4
Make R1 the ASBR.
Configure R1 as an ASBR and assign the OSPF Router-ID.
5530-24TFD(config)# router ospf
Nortel Ethernet Routing Switch 5500 Series
Configuration-IP Routing Protocols
NN47200-503 03.01 Standard
5.1 27 August 2007
Copyright © 2005-2007, Nortel Networks
.