Filter
Top Products
RASCAL Programmer’s Manual
___________________________________________________________________________
______________________________________________________________________________
2-6 TC9450PM Rev. C 8/11/98
Positioning a Field on a Format
You use a coordinate system to place a field on a format. The following diagram
shows this system.
The (0,0) coordinate is the upper left-hand corner of the format. For example, to
position a field at (40,30) move 40 dots to the right of (0,0) and 30 dots down.
The maximum length of a format is 1015 dots (5 inches). The maximum width is
383 dots (1.89 inches). For continous mode, use supplies up to a maximun of 2.2
inches (446 dots). For peel mode, use supplies up to a maximum of 2.05 inches
(416 dots). Contact Monarch if you have special label requirements.