Filter
Top Products
RASCAL Programmer’s Manual
______________________________________________________________________________
______________________________________________________________________________
3-12 TC9450PM Rev. C 8/11/98
Identifier
The field identifier. Enter any of the following characters: 0-9,
A-Z, a-z, :, ;, <, =, >, ?, @, [, \, ], -, and ‘. For more readable
data streams, Monarch recommends that you use only
alphanumeric characters. You cannot change this identifier
after you create the field.
To delete all fields and formats, enter $.
If you want to add a field with the same identifier as an existing
field, delete the existing field first.
Function R Add
DR Delete
Use the following parameters only when function is R.
w-coord
The point along the width axis where the field starts (0 to 383).
The value you enter is a measurement (in dots) from the left side
of the supply to the point (as the feed direction points away from
you).
W-coord and l-coord specify the upper-left corner of the field.
l-coord
The point along the length axis where the field starts (0 to
1015). The value you enter is a measurement (in dots) from the
bottom of the supply to the point (as the feed direction points
away from you).
width
The width of the field in dots (1 to 383).
The sum of w-coord and width may not exceed 383, which is
the width of the printhead.
length
The length of the field in dots (1 to 1015).
The sum of l-coord and length may not exceed 1015. If the
field is a bar code, enter at least 46 for a scannable bar code.
For the field to print, length must be at least the cell height of
the font you use. See Chapter 2, “Fields and Formats,” for the
cell heights. For a bar code, the minimum height is 16 dots.
NOTE:A dot is 1/203rd of an inch.