Filter
Top Products
Chapter 3. Command Reference
______________________________________________________________________________
______________________________________________________________________________
TC9450PM Rev. C 8/11/98 3-11
NOTE:For readability, you can put a carriage return, a line feed, or a carriage
return and line feed after each ¦ character in the list of data for the fields.
For example,
^P¦A¦10¦
Field 1¦
Field 2¦
Field 3¦^
Example
^P¦1¦1¦ACME HARDWARE¦43373737376¦^
This command prints one label using format 1, which contains two fields. Field 1 is
ACME HARDWARE, and field 2 is 43373737376.
Define Field (^R)
The Define Field command specifies information the printer must know about a
field. In defining the location of this field, determine where the upper-left corner of
the field is.
A field definition stays in the printer until you erase it with this command. You can
store a maximum of 30 field definitions in the printer and use up to 30 fields per
format. The printer discards definitions overflowing into available space.
NOTE:You can use a file in multiple formats.
Syntax
^R¦identifier¦function¦w-coord¦l-coord¦width¦length¦
txtfld_type¦rotation¦justification¦field_type¦mul_1¦mul_
2¦prt_attrib¦data_attrib¦fixed_data¦^
NOTE:The syntax for this command is spread over three lines due to space
limitations in this manual. In an actual data stream, the command must
fit on one line.