Filter
Top Products
Chapter 3. Command Reference
______________________________________________________________________________
______________________________________________________________________________
TC9450PM Rev. C 8/11/98 3-21
NOTE:Be sure to always back up your fonts.
Syntax
{W,identifier,A,R,mem-req¦
font_data¦
}
NOTE:This command starts with a { character and ends with a } character,
instead of using the ^ character in both places, as the other commands do.
identifier
The font identifier.
mem-req One-sixteenth of the memory (in bytes) needed to save the font
image. For example, if the font requires 1600 bytes, enter 100.
This value ranges from 0 to 2048.
font_data
The data representing the font images (available from Monarch).