Filter
Top Products
Chapter 3. Command Reference
______________________________________________________________________________
______________________________________________________________________________
TC9450PM Rev. C 8/11/98 3-9
Syntax
^l¦function¦memory¦identifer¦mem_req¦^
function A Add a graphic.
D Delete all graphics , fonts, fields, or formats.
I Take inventory.
memory If function is A, enter R (printer RAM). Otherwise, leave this
field blank (but remember to include the split vertical bar).
identifier The graphic identifier. Enter
$ to delete all graphics or fonts. If
function is I, leave this field blank (but remember to include the
split vertical bar).
mem_req If function is A, enter the amount of memory for the graphic in
bytes. Use the value listed for the file when you use the DOS DIR
command.
If the function is D, enter either A (to delete all fonts and
graphics) or G (to delete all graphics, fields, and formats).
Example
^l¦A¦R¦H¦5734¦^
This command specifies the header information for graphic H, which is 5734 bytes
long. After receiving this command, send the graphic file to the printer.
Select Printer Operation Mode (^O)
The Select Printer Operation Mode command sets the printer to print and feed
• continuously (without pause) until the end of the batch.
• on-demand, or one at a time. The user must press [Feed] to print each
label.
Continuous mode is the default print mode. After the printer mode has been
changed, the printer stays at that mode until it is changed again.