Filter
Top Products
49
These fields should be completed as follows:
Address Field: Enter the address of the encoder. The default “loop back” address
is typically “127.0.0.1”.
Port Field: Enter the Port that the encoder is using. The port number can be
found in the PE Controller Configuration window (See Figure 4-105).
Fig. 4-105
Password Field: Enter the password that was entered in the PE-Controller to
access the encoder.
Admin Password Field: Enter the admin password that was entered in the PE-
Controller to provide administration rights (See Figure 4-106).
Fig. 4-106
Note: Unless encoder profiles are going to be changed, it is often not necessary to
enter an administration password.
Clicking the Configure button will launch the Encoder Settings window for the
encoder, either Real or Microsoft, that is being configured (See Figures 4-107
through 4-109 and 4-110 though 4-112, respectively).
Fig. 4-107 (RN) Fig. 4-108 (RN)