Filter
Top Products
A – Command Line Interface
Set Setup Command
A-38 59022-04 B
system
Prompts you in a line-by-line fashion to change system configuration settings.
Table A-12 describes the system configuration fields. For each parameter, enter a
new value or press the Enter key to accept the current value shown in brackets.
Notes The two components of security are user authentication and fabric security. The
user must be authenticated before gaining access to a switch. If an invalid
account name/password combination is entered, that user can not access the
switch, and thus can not gain access to the fabric. If security is enabled (True) and
a valid account name/password combination is entered, that user can access the
switch but can not execute any command that exceeds their authority (privileges)
level. If security is disabled (False) and a valid account name/password
combination is entered, that user has access to all switches in the fabric and can
execute all commands (both user and admin), regardless of their authority
(privileges) level.
Table A-12. System Configuration Settings
Entry Description
Eth0NetworkAddress Internet Protocol (IP) address for the Ethernet port.
Eth0NetworkMask Subnet mask address for the Ethernet port.
Eth0GatewayAddress IP address gateway.
Eth0NetworkDiscovery Boot Method (1 - Static, 2 - Bootp, 3 - DHCP, 4 - RARP)
AdminTimeout Specifies the amount of time in minutes the switch waits
before terminating an idle Admin session. Zero (0)
disables the time out threshold. The default is 30, the
maximum is 1440.
Security Enabled Enables or disables the enforcement of account names
and passwords.
Local Log Enabled Enables or disables the saving of log information on the
switch.
Remote Log Enabled Whether remote logging of is enabled or disabled. If
enabled, log information is saved to a remote host that
supports the syslog protocol.
Remote LogHost IP
Address
The IP address of the host that will receive the remote
log information if remote logging is enabled.