Filter
Top Products
2 – Using SANbox Manager
Uninstalling SANbox Manager
59022-04 B 2-7
(Enable is the default). Refer to ”Setting Preferences” on page 2-8 for more
information.
To exit a SANbox Manager application session, open the File menu and select
Exit. The system prompts you to enter a password with which to protect the
default fabric view file as shown in Figure 2-4. Choose one of the following:
■ Enter a password and choose the Save View File button to save the current
set of fabrics in the default fabric view file (fc_view.dft) in the working
directory.
■ Choose the Exit Without Saving button to exit the application without
saving the current fabrics to the default fabric view file.
■ Choose the Cancel Exit button to cancel the exit operation.
Figure 2-4 Save Current Fabric View Window
If the default fabric view file was saved with a password, the next time you open
the SANbox Manager application, you will be prompted for the password in the
Load Default Fabric View File window as shown in Figure 2-2. Your fabric opens
after entering the password.
2.4
Uninstalling SANbox Manager
A program to uninstall SANbox Manager was installed as part of the SANbox
Manager installation process. The Uninstaller Data folder in the Install folder
contains the uninstall program (Uninstall SANbox Manager). Also, a shortcut/link
to the uninstall program was installed in the installation directory during the
SANbox Manager installation process. The default installation directory is
/QLogic_Corporation/SANbox_Manager.
To uninstall the SANbox Manager application:
1. Browse for the uninstall program file or the shortcut/link that points to the
uninstall program file. The uninstall program shortcut is in the same folder as
the program shortcut (Start menu, program group, on, or user specified) that
is used to start the SANbox Manager application.