Filter
Top Products
3 – Managing Fabrics
Zoning a Fabric
3-12 59022-04 B
■ Maximum number of zonesets is 256
■ Maximum number of zones is 256
■ Maximum total number of zone set members is 1000
■ Maximum number of members per zone is 2000
■ Maximum number of aliases is 256
■ Maximum number of members per alias is 2000
■ Maximum total number of zone and alias members is 2000
3.5.1.5
Zoning Configuration
You can set the Auto Save and Default Visibility zoning configuration parameters
using SANbox Manager or the Set Config Zoning command. The Auto Save
parameter determines whether changes to the active zone set that a switch
receives from other switches in the fabric will be saved to permanent memory on
that switch. The Default Visibility parameter permits or prohibits communication
between switches when there is no active zone set. Refer to ”Using the Zoning
Config Window” on page 3-12 for information about zoning configuration using
SANbox Manager. Refer also to the Set Config Command on page A-25 for
information about zoning configuration using the CLI.
3.5.2
Using the Zoning Config Window
Use the Zoning Config window to change the Auto Save and Default Visibility
configuration parameters. In the faceplate display, open the Zoning menu and
select Edit Zoning Config to open the Zoning Config window shown in
Figure 3-3. After making changes, choose the OK button to put the new values
into effect.
Figure 3-3 Zoning Config Window