Filter
Top Products
Chapter 4 - Control from the Supervisory Port HCD-E1
Installation & Operation Manual
4-42 HCD-E1 Command Set Description 11/01/00 19:23
DSP ST LINE
Purpose
Display status information on the HDSL lines.
Syntax
DSP ST LINE [Option]
Use
•
To display the current status information for HDSL line 1, type:
DSP ST LINE 1<CR>
or
DSP ST LINE<CR>
HCD-E1 performs the command and displays the date and time
followed by the HCD-E1 prompt.
•
To monitor continuously line 1 status information, type:
DSP ST LINE 1/R<CR>
or
DSP ST LINE /R<CR>
The display will be automatically updated. To stop the monitoring,
press CTRL+C.
•
To display the current status information for HDSL line 2, type:
DSP ST LINE 2<CR>
HCD-E1 performs the command and displays the date and time
followed by the HCD-E1 prompt.
•
To monitor continuously line 2 status information, type:
DSP ST LINE 2/R<CR>
The display will be automatically updated. To stop the monitoring,
press CTRL+C.
Display Format
A typical HDSL line status display is shown below.
STATUS OF LINE - 1
LINE LOOP = LOCAL
=====
NO
LINE ALARMS = SYNC LOSS
=========
SIGNAL LOSS
===========
OFF OFF
HRPT LOOP = NO