Filter
Top Products
HCD-E1 Installation & Operation Manual Chapter 4 - Control from the Supervisory Port
11/01/00 19:23 HCD-E1 Command Set Description 4-45
Use
•
To view the current system status, type:
DSP ST SYS<CR>
HCD-E1 performs the command and displays the date and the time
followed by the HCD-E1 prompt.
Display Format
A typical status information display is shown below.
NODE = 0
NAME = 'HCD-E1 name'
NODAL CLOCK = INT
HTU TYPE = CENTRAL
REMOTE HTU TYPE = HCD-E1
SOFTWARE VER = 2.0
HARDWARE VER = 0.0
DTE INT. TYPE CH 1 = V35
DTE INT. TYPE CH 2 = RS530
HRPT: = NTU_SIDE
HRPT SOFTWARE VER = 1.0
HRPT HARDWARE VER = 1.0
The system status fields are described below (from top to bottom):
NODE
The node number of the HCD-E1
NAME
The node name of the HCD-E1 (if you have defined it
with the DEF NAME command)
NODAL CLOCK
For a unit configured as central, indicates the current
source for the HCD-E1 system clock: INT, SL, CH1 or
CH2.
For a unit configured as remote, always shows LBT.
HCD TYPE
Indicates the function of the HCD-E1: CENTRAL or
REMOTE
REMOTE HCD TYPE
Indicates type of the unit at the remote end of the HDSL
link
SOFTWARE VER
HCD-E1 software version
HARDWARE VER
HCD-E1 hardware version
DTE INT. TYPE CH 1
Type of interface of data channel 1
DTE INT. TYPE CH 2
Type of interface of data channel 2