Filter
Top Products
HCD-E1 Installation & Operation Manual Appendix E - IR-IP Interface Module
Advanced Setup Menu E-17
DLCI
When the Self Learn parameter is DISABLED, use this parameter to specify
the DLCI used for exchanging maintenance protocol messages.
CIR
Used to specify the maximum amount of data, in bits, which the Frame
Relay network guarantees to transfer during the measurement interval (the
measurement interval is usually one second).
The value of this parameter is obtained from your Frame Relay service provider.
EIR
Used to specify the maximum amount of data, in bits, that the Frame Relay
network will attempt to deliver during the measurement interval. The value
of this parameter is obtained from the Frame Relay service provider.
A typical Frame Relay Protocol Parameters menu is shown in Figure D-12.
IR_IP <IR-IP> S/W Ver. 1.00 31/IR (date)
Quick Setup
Management Access
Advanced Setup
.....................................................................
Device identification
Interface Parameters
Protocol Parameters
=====================================================================
1. Self Learn :[ Enabled ]
2. Maintenance Protocol :[ ANSI T1.617 ANNEX D ]
3. DLCI (0-None) :0..
4. CIR :0.......
5. EIR :64000...
Press one of the numbers to select or ESC:
Figure E-12 Frame Relay Protocol Parameters Menu
WAN Protocol
Parameters – PPP
Protocol
The PPP Protocol Parameters menu is used to configure the parameters
PPP WAN for protocol (the WAN protocol is selected by means of the (the
WAN protocol is selected by means of the Quick Setup Menu) in
Figure E-6.
To access the Protocol Parameters menu:
•
From the Advanced Setup menu, type 3.
Header and Control Field Compression
Used to control the use of header and control field compression type
according to RFC 1661. It is strongly recommended that this compression be
used for troubleshooting only.