Filter
Top Products
HCD-E1 Installation & Operation Manual Appendix E - IR-IP Interface Module
Advanced Setup Menu E-15
Device Name
Select this parameter to assign an arbitrary name to IR-IP for identification
by the system manager (up to eight characters). The assigned name is
displayed in the screen header.
Contact Person
Select this parameter to enter the name of the person to be contacted with
matters pertaining to this equipment unit.
System Location
Select this parameter to enter the physical location of the device.
Interface
Parameters Menu
The Interface Parameters menu is used to control the operation of IR-IP
interfaces.
To access the Interface Parameters menu:
•
From the Advanced Setup menu, type 2.
The Interface Parameters menu appears (Figure E-11).
IR_IP <IR-IP> S/W Ver. 1.00 31/IR (date)
Quick Setup
Management Access
Advanced Setup
.................................................................
Device identification
Interface Parameters
=================================================================
1. LAN Status :[ Open ]
2. WAN Status :[ Open ]
3. WAN Throttle :[ Full ]
4. Aging Timeout (min) :5
Press one of the numbers to select or ESC:
Figure E-11 Interface Parameters Menu
LAN Status
Used to enable/disable the flow of packets through LAN interface:
•
Open – the flow of packets is enabled.
•
Closed – the flow of packets is disabled. As a result, IR-IP does not
accept, nor sends packets to the LAN, but its WAN interface may still be
active, and can interact with other IP hosts on the WAN.