Filter
Top Products
300M Wireless N Router RNX-N300RT User Manual
¾ Remote Management IP Address - This is the current address you will use when
accessing your Router from the Internet. This function is disabled when the IP
address is set to the default value of 0.0.0.0. To enable this function change 0.0.0.0 to
a valid IP address. If set to 255.255.255.255, then all the hosts can access the Router
from internet.
)
Note:
1) To access the Router, you should type your Router's WAN IP address into your
browser's address (in IE) or Location (in Navigator) box, followed by a colon and the
custom port number. For example, if your Router's WAN address is 202.96.12.8,
and the port number used is 8080, please enter http://202.96.12.8:8080
in your
browser. Later, you may be asked for the Router's password. After successfully
entering the username and password, you will be able to access the Router's
web-based utility.
2) Be sure to change the Router's default password to a very secure password.
4.10 Access Control
Figure 4-43 Access Control
There are four submenus under the Access Control menu as shown in Figure 4-43: Rule,
Host, Target and Schedule. Click any of them, and you will be able to configure the
corresponding function.
Please Note: The internet loading will be slow down when under “Access Control”
due to all TCP contents of the website will be examine by RNX-N300RT under the
set rules.
4.10.1 Rule
Choose menu “Access Control → Rule”, you can view and set Access Control rules in
-80-